Description
Double-sided Powder-coated PA Nylon Spring Steel Sheet for the Original Prusa i3 MK3/S/+ and MK2.5/S.
OVERVIEW:
The MK52 heatbed has embedded high Curie temperature magnets. These magnets are able to firmly hold removable spring steel sheets.This print sheet is specially designed to print polyamide-based filaments, especially the Prusament PA11 Carbon Fiber Black. The PA11-type materials have generally a lower adhesion on textured or satin print sheets. This sheet has a special surface finish that increases the adhesion and is perfect for Prusament PA11.
IMPORTANT!
The surface of this sheet should be cleaned only with pure water. Using common agents such as IPA or Acetone will lead to a quick deterioration of the surface. Using a glue stick is no longer required and recommended. To clean grease-coated areas, use clean water with a drop of dishwashing detergent.Note:
Consumable parts, such as PEI sheets (smooth, textured, nylon, etc.) are not covered by warranty as the coatings are designed to diminish over time unless failure has occurred due to a defect in materials or workmanship. Cosmetic damage, including but not limited to scratches, dents, cracks or other cosmetic damage is also not covered by the warranty. Only defective sheets on arrival are covered by warranty.As a result of the temperatures to which the plate is exposed during printing, its surface gradually becomes glossier or may develop smaller, duller areas. This visual change does not adversely affect the printing properties and is not considered a reason for a warranty claim.
ATTRIBUTES
| Pros | Cons | ||
| Great for polyamide-based materials | Suitable only for polyamide-based materials and PETG. Other materials tend to detach mid-print | ||
| No need for a glue stick | Can be damaged with IPA and acetone | ||
| Can be cleaned just with water | |||
| Prints automatically detach after the sheet cools down |